Planet WGSW-52040 Configuration Manual page 54

3． BOOTP configuration
4． DHCP configuration
1. Enable VLAN port mode
Command
Global Mode
interface vlan <vlan-id>
no interface vlan <vlan-id>
2. Manual configuration
Command
VLAN Interface Mode
ip address <ip_address> <mask>
[secondary]
no ip address <ip_address> <mask>
[secondary]
ipv6 address <ipv6-address /
prefix-length> [eui-64]
no ipv6 address <ipv6-address /
prefix-length>
3. BOOTP configuration
Command
VLAN Interface Mode
ip bootp-client enable
no ip bootp-client enable
4. DHCP configuration
Command
VLAN Interface Mode
ip bootp-client enable
no ip bootp-client enable
Explanation
Create VLAN interface (layer 3 interface); the
no command deletes the VLAN interface.
Explanation
Configure IP address of VLAN interface; the
no command deletes IP address of VLAN
interface.
Configure IPv6 address, including
aggregation global unicast address, local site
address and local link address. The no
command deletes IPv6 address.
Explanation
Enable the switch to be a BootP client and
obtain IP address and gateway address
through BootP negotiation; the no command
disables the BootP client function.
Explanation
Enable the switch to be a DHCP client and
obtain IP address and gateway address
4-7