Concluding Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Accessible drives
Figure 191: Installing the LSD module
Ê Connect the LSD cable to the LSD module (1).
Ê Connect the LSD cable to the connector SMB1 of the system board (2).
Ê Route the LSD cable through the upper cable guide (3).

12.2.5 Concluding steps

Perform the following procedures:
"Installing the fan box" on page 184
Ê
"Installing the air duct" on page 74
Ê
"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
"Connecting the server to the power source" on page 81
Ê
"Closing the rack door" on page 84
Ê
340 Upgrade and Maintenance Manual
77.
RX300 S7