Removing The Front Panel Module; Removing The Front Lan Connector; Installing The New Front Lan Connector; Re-Installing The Front Panel Module - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Front panel

13.3.3.3 Removing the front panel module

Ê Remove the front panel module as described in section
panel module" on page

13.3.3.4 Removing the front LAN connector

Ê Remove the defective front LAN connector as described in section
"Removing the front LAN connector" on page

13.3.3.5 Installing the new front LAN connector

Ê Install the new front LAN connector as described in section
front LAN connector" on page

13.3.3.6 Re-installing the front panel module

"Installing the front panel module" on page 413
Ê

13.3.3.7 Concluding steps

Perform the following procedures:
"Installing the fan box" on page 184
Ê
"Installing the air duct" on page 74
Ê
"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
"Connecting the server to the power source" on page 81
Ê
"Closing the rack door" on page 84
Ê
"Looking up changed MAC / WWN addresses" on page 108
Ê
"Updating the NIC configuration file in a Linux environment" on page 105
Ê
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page
"Enabling BitLocker functionality" on page 107
Ê
444
410.
428.
Upgrade and Maintenance Manual
"Removing the front
439.
77.
112.
"Installing the
RX300 S7