Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual page 496

System board and components
– Heat sinks: see section
– Memory modules: see section
page 281
I
Install all memory modules into their original slots.
– Expansion cards: see section
I
Install all expansion cards into their original slots.
– UFM board: install the UFM spacer to the system board and install the
UFM board see section
– TPM board (if applicable): see section
page 468
"Installing the power backplane" on page 133
Ê
"Installing the fan box" on page 184
Ê
"Installing the air duct" on page 74
Ê
"Mounting the server cover" on page 76
Ê
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
"D2939 BIOS Setup Utility for PRIMERGY RX300 S7 / TX120 S3 Reference
Manual".
"Sliding the server into the rack" on page 80
Ê
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect all external cables.
"Connecting the server to the power source" on page 81
Ê
"Closing the rack door" on page 84
Ê
"Updating or recovering the system board BIOS and iRMC" on page 92
Ê
"Verifying system information backup / restore" on page 94
Ê
"Verifying the system time settings" on page 103
Ê
496
"Installing processor heat sinks" on page 325
"Installing a memory module" on
"Installing expansion cards" on page 191
"Installing the UFM board" on page 456
Upgrade and Maintenance Manual
"Installing the TPM board" on
77.
RX300 S7