Preliminary Steps; Removing The Air Duct With An Fbu - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

9.6.2.2

Preliminary steps

Perform the following procedures:
"Opening the rack door" on page 64
Ê
"Locating the defective server" on page 56
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting power cords" on page 66
Ê
"Extending the server out of the rack" on page 69
Ê
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
"Removing the server cover" on page 72
Ê
9.6.2.3

Removing the air duct with an FBU

Figure 117: Disconnecting the FBU cable
Ê Carefully disconnect the FBU cable from the RAID controller (see arrow).
Ê Pull the FBU cable through the gap in the air duct.
RX300 S7
Upgrade and Maintenance Manual
Expansion cards and backup units
70.
249