Removing The Sas Raid Controller; Concluding Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.3.2.3

Removing the SAS RAID controller

Figure 89: Removing the SAS RAID controller
Ê Loosen the screw on the RAID card holder (2).
Ê Carefully pull up on the SAS RAID controller in a vertical motion and remove
it from its slot (1).
9.3.2.4

Concluding steps

Perform the following procedures:
"Installing the air duct" on page 74
Ê
"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
208 Upgrade and Maintenance Manual
RX300 S7