Installing The Processor; Opening The Load Plate Of The Processor Socket - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Processors
"Removing the server cover" on page 72
Ê
"Removing the air duct" on page
Ê

11.2.3 Installing the processor

11.2.3.1 Opening the load plate of the processor socket

I
This description applies to the following procedures:
– Installing the second CPU in a mono-processor configuration
– Transfering a CPU after replacing the system board (see section
"Swapping processors" on page
Figure 148: Opening socket release lever 1
Ê Unlatch the socket release lever marked Open 1st by pushing it down and
away from the socket (1).
Ê The socket release lever will slightly lift up (2).
292
73.c
Upgrade and Maintenance Manual
495)
RX300 S7