Concluding Software Tasks; Closing The Rack Door - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Basic hardware procedures
4.11

Concluding software tasks

Ê Perform the following software tasks to put the server back in operation:
- "Resetting the boot retry counter" on page 99
- "Verifying the system time settings" on page 103
- "Viewing and clearing the System Event Log (SEL)" on page 104
- "Updating the NIC configuration file in a Linux environment" on
page 105
- "Enabling BitLocker functionality" on page 107
- "Performing a RAID array rebuild" on page 108
- "Looking up changed MAC / WWN addresses" on page 108
4.12

Closing the rack door

The PRIMECENTER M1 rack is equipped with a split front door. The left-hand
door contains an interlocking system that can be locked and opened with a key.
Optionally, a revolving door knob can be mounted for key-less locking. To close
and lock the rack, proceed as follows:
Ê Close the right-hand door first, then the left-hand door.
Ê Insert and turn the key clockwise by 180 degrees.
If applicable, turn the door knob clockwise by 180 degrees.
I
For further information, refer to the "PRIMECENTER Rack System"
assembly guide available online at
84 Upgrade and Maintenance Manual
http://manuals.ts.fujitsu.com .
RX300 S7