Replacing An Odd; Required Tools; Preliminary Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

"Closing the rack door" on page 84
Ê
"Enabling BitLocker functionality" on page 107
Ê
12.7

Replacing an ODD

Upgrade and Repair Units (URU)
Average task duration: 10 minutes

12.7.1 Required tools

Preliminary and concluding steps: tool-less
●
Replacing an ODD:
●
– Phillips PH0 / (+) No. 0 screw driver

12.7.2 Preliminary steps

Perform the following procedures:
Ê Ask the system administrator to eject all remaining backup or optical media
from the backup or optical disk drive before removing it from the server.
"Disabling BitLocker functionality" on page 85
Ê
"Opening the rack door" on page 64
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting power cords" on page 66
Ê
"Extending the server out of the rack" on page 69
Ê
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
"Removing the server cover" on page 72
Ê
"Removing the air duct" on page 73
Ê
RX300 S7
Upgrade and Maintenance Manual
Accessible drives
70.
355