Removing The Modular Lan Controller; Installing The Modular Lan Controller; Concluding Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
"Disconnecting power cords" on page 66
Ê
"Extending the server out of the rack" on page
Ê
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
"Removing the server cover" on page 72
Ê
"Removing the air duct" on page 73
Ê
9.4.3.3

Removing the Modular LAN controller

Ê If applicable, remove SFP+ transceiver modules from the Modular LAN
controller to be removed, as described in section
transceiver module" on page
Ê Remove the defective Modular LAN controller as described in section
"Removing the Modular LAN controller" on page
Ê If the slot bracket on the defective Modular LAN controller is to be reused,
remove it from the board as described in section
LAN controller" on page
9.4.3.4

Installing the Modular LAN controller

Ê If applicable, install a slot bracket on the new Modular LAN controller as
described in section
Ê Install the new Modular LAN controller as described in section
Modular LAN controller" on page
Ê If applicable, reinstall SFP+ transceiver modules on the new Modular LAN
controller, as described in section
page 262.
9.4.3.5

Concluding steps

Perform the following procedures to complete the task:
"Installing the air duct" on page 74
Ê
"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
226
268.
215.
"Preparing the Modular LAN controller" on page
213.
"Installing SFP+ transceiver modules" on
Upgrade and Maintenance Manual
69.
70.
"Removing an SFP+
221.
"Preparing the Modular
"Installing the
215.
RX300 S7