Required Tools; Preliminary Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

System board and components
Do not throw batteries into the trash can. Lithium batteries must be
●
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section "Environmental
●
protection" in the PRIMERGY RX300 S7 Operating Manual.
Ensure to insert the CMOS battery with the positive pole facing
●
up!

14.1.1 Required tools

Preliminary and concluding steps: tool-less
●
Replacing the battery: tool-less; recommended: tooth pick
●

14.1.2 Preliminary steps

Perform the following procedures:
"Opening the rack door" on page 64
Ê
"Locating the defective server" on page 56
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting power cords" on page 66
Ê
"Extending the server out of the rack" on page 69
Ê
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
"Removing the server cover" on page 72
Ê
"Removing the air duct" on page 73
Ê
452 Upgrade and Maintenance Manual
70.
RX300 S7