Expansion cards and backup units
9.6.2.4
Removing the FBU holder from the air duct
Figure 118: Removing the FBU holder from the air duct (A)
Ê Lift up the green locking handle on the FBU holder (1) while sliding the FBU
holder to the left as far as it will go (2).
I
After that, the fixation bolts on the air duct will rest in the wide ends of
the keyhole slots on the holder.
Ê Lift the FBU holder from the air duct (3).
9.6.2.5
Concluding steps
Perform the following procedures:
"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
"Connecting the server to the power source" on page 81
Ê
"Closing the rack door" on page 84
Ê
250
Upgrade and Maintenance Manual
77.
RX300 S7