System board and components
"Closing the rack door" on page 84
Ê
"Enabling BitLocker functionality" on page 107
Ê
14.4
Onboard SAS enabling key
I
The onboard SAS enabling key needs to be installed in order to enable
SAS connector SAS 1-4 on the system board.
14.4.1 Installing the onboard SAS enabling key
Field Replaceable Units (FRU)
Average task duration: 5 minutes
14.4.1.1 Required tools
Preliminary and concluding steps: tool-less
●
Replacing the onboard SAS enabling key: tool-less
●
14.4.1.2 Preliminary steps
Perform the following procedures:
"Disabling BitLocker functionality" on page 85
Ê
"Locating the defective server" on page 56
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting power cords" on page 66
Ê
"Extending the server out of the rack" on page 69
Ê
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70
"Removing the server cover" on page 72
Ê
"Removing the air duct" on page
Ê
482
73.
Upgrade and Maintenance Manual
RX300 S7