Usb Flash Module (Ufm); Installing The Ufm Board; Required Tools; Preliminary Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

System board and components
14.2

USB Flash Module (UFM)

This section provides information on how to install, remove or replace the USB
Flash Module (UFM).

14.2.1 Installing the UFM board

Field Replaceable Units (FRU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes

14.2.1.1 Required tools

Preliminary and concluding steps: tool-less
●
Installing the UFM: tool-less
●

14.2.1.2 Preliminary steps

Perform the following procedures:
"Disabling BitLocker functionality" on page 85
Ê
"Disabling SVOM boot watchdog functionality" on page 86
Ê
"Opening the rack door" on page 64
Ê
"Locating the defective server" on page 56
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting power cords" on page 66
Ê
"Extending the server out of the rack" on page 69
Ê
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
"Removing the server cover" on page 72
Ê
456 Upgrade and Maintenance Manual
70.
RX300 S7