Installing The Fbu Holder Onto The Air Duct; Installing The Air Duct With An Fbu - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê Connect the cable end on the FBU module to the FBU adapter cable as
shown.
9.6.1.5

Installing the FBU holder onto the air duct

I
The Installation of an FBU onto the air duct is similar to the installation of
a BBU see section
page 230
9.6.1.6

Installing the air duct with an FBU

Figure 114: Connecting the FBU to the controller
Ê Insert the air duct.
Ê Thread the FBU cable through the gap in the air duct.
Ê Tilt up the air duct a little.
246
"Installing the BBU holder onto the air duct" on
Upgrade and Maintenance Manual
RX300 S7