Removing A 3.5-Inch Hdd Module; Installing A 3.5-Inch Hdd Module; Concluding Steps; Inch Hard Disk Drives / Solid State Drives - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
Only applicable for removing intact HDD modules:
Ê Before removing a non-defective HDD module, put the drive into "Offline"
mode using your RAID configuration software.
I
For further information, please refer to the "ServerView Suite RAID
Management" user guide, available online at http://manuals.ts.fujitsu.com.
7.2.4.3

Removing a 3.5-inch HDD module

"Removing a 3.5-inch HDD module" on page 143
Ê
7.2.4.4

Installing a 3.5-inch HDD module

"Installing 3.5-inch HDD modules" on page 140
Ê
7.2.4.5

Concluding steps

Perform the following procedures:
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
"Closing the rack door" on page 84
Ê
7.3

2.5-inch hard disk drives / solid state drives

7.3.1

Mounting order for 2.5-inch HDDs / SSDs

Maximum configuration: 16x 2.5-inch HDDs / SSDs
General equipping rules
– Solid state drives (SSDs) are always equipped before installing hard disk
drives.
– If only one HDD/SSD module is installed, the HDD/SSD module will be
installed in position 1. Empty bays must be equipped with a dummy module.
146
108.
Upgrade and Maintenance Manual
"Performing a RAID
RX300 S7