Removing The Front Lan Connector; Required Tools; Preliminary Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Front panel
Ê Accessing the iRMC S3 using the front management LAN connector is only
possible via the preset IP address 192.168.1.1 and cannot be configured
otherwise.
Configure your client computer to use any static IP address on subnet
192.168.1.x (except 192.168.1.1) with subnet mask 255.255.255.0.

13.3.2 Removing the front LAN connector

Field Replaceable Units (FRU)
Average task duration: 10 minutes

13.3.2.1 Required tools

Preliminary and concluding steps: tool-less
●
Removing the front LAN connector:
●
– Phillips PH2 / (+) No. 2 screw driver

13.3.2.2 Preliminary steps

Perform the following procedures:
"Disabling BitLocker functionality" on page 85
Ê
"Opening the rack door" on page 64
Ê
"Locating the defective server" on page 56
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting power cords" on page 66
Ê
"Extending the server out of the rack" on page 69
Ê
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
"Removing the server cover" on page 72
Ê
"Removing the air duct" on page 73
Ê
436 Upgrade and Maintenance Manual
70.
RX300 S7