Preliminary Steps; Removing The Tpm - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

System board and components
– TPM bit insert
– thin slotted screw driver (
( )
* For the Japanese market:
– Dedicated TPM screw driver (CWZ8291A)
– TPM module fixing tool (S26361-F3552-L909)

14.3.3.2 Preliminary steps

Perform the following procedures:
"Disabling BitLocker functionality" on page 85
Ê
"Opening the rack door" on page 64
Ê
"Locating the defective server" on page 56
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting power cords" on page 66
Ê
"Extending the server out of the rack" on page 69
Ê
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
"Removing the server cover" on page 72
Ê
"Removing the air duct" on page 73
Ê

14.3.3.3 Removing the TPM

Ê Remove the TPM board as described in section
on page 474.
Ê Leave the TPM spacer on the system board when removing the defective
TPM board.
480
( )
*
2 x 0.4 mm)
Upgrade and Maintenance Manual
( )
*
70.
"Removing the TPM board"
RX300 S7