Concluding Steps; Removing An Fbu; Required Tools - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.6.1.7

Concluding steps

Perform the following procedures:
"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
"Connecting the server to the power source" on page 81
Ê
Ê If applicable, update the firmware of the RAID controller that has been
connected to the FBU as described in section
firmware" on page
"Enabling SVOM boot watchdog functionality" on page 101
Ê
"Closing the rack door" on page 84
Ê
9.6.2

Removing an FBU

Upgrade and Repair Units (URU)
Average task duration: 5 minutes
V
CAUTION!
Do not throw backup units into the trash can. Batteries must be disposed
of in accordance with local regulations concerning special waste.
For further safety information, please refer to section
protection" on page
9.6.2.1

Required tools

Preliminary and concluding steps: tool-less
●
Removing an FBU: tool-less
●
248
96.
53.
Upgrade and Maintenance Manual
77.
"Updating RAID controller
"Environmental
RX300 S7