Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual page 412

Front panel
Figure 250: Removing the front panel module
Ê Push the locking latches upward (1) to disengage the locking mechanism.
Ê Carefully pull the front panel module out of its bay (2).
V
CAUTION!
Ensure that none of the cables are strained or damaged!
Ê If the front VGA connector has been installed in the defective front panel
module, remove the cable as described in section
connector" on page
Ê If the front LAN connector has been installed in the defective front panel
module, remove the cable as described in section
connector" on page
412
423.
423.
Upgrade and Maintenance Manual
"Removing the front VGA
"Removing the front VGA
RX300 S7