Installing An Rdx/Dat Drive In 2.5-Inch Version; Required Tools; Preliminary Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

12.11 Installing an RDX/DAT drive in 2.5-inch
version
Upgrade and Repair Units (URU)
Average task duration: 10 minutes

12.11.1 Required tools

Preliminary and concluding steps: tool-less
●
Installing accessible drives:
●
– Phillips PH2 / (+) No. 2 screw driver

12.11.2 Preliminary steps

Perform the following procedures:
"Disabling BitLocker functionality" on page 85
Ê
"Opening the rack door" on page 64
Ê
"Locating the defective server" on page 56
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting power cords" on page 66
Ê
"Extending the server out of the rack" on page 69
Ê
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
"Removing the server cover" on page 72
Ê
"Removing the front cover" on page 501
Ê
"Removing the air duct" on page 73
Ê
"Removing the fan box" on page 183
RX300 S7
Upgrade and Maintenance Manual
Accessible drives
70.
371