Installing A New Fbu; Concluding Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Figure 120: Disconnecting the FBU adapter cable from the FBU
Ê Press down on the locking latch on the FBU cable and disconnect the FBU
adapter cable.
9.6.3.5

Installing a new FBU

Ê Install the new FBU into the FBU holder as described in section
the FBU" on page
"Installing the FBU holder onto the air duct" on page 246
Ê
Ê Connect the FBU to the controller.
9.6.3.6

Concluding steps

Perform the following procedures:
"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
"Connecting the server to the power source" on page 81
Ê
RX300 S7
244.
Upgrade and Maintenance Manual
Expansion cards and backup units
77.
"Preparing
253