Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual page 519

Ê If applicable connect the optional front LAN and front VGA cables to the
system board see sections
and "Installing the front VGA connector" on page
Figure 338: Connecting cables
Ê Connect the power cable to the connector of the power cable (1).
Ê Connect the cable C11 to connector X1 of the 4x 2.5-inch HDD
backplane (2) and the connector MLC2 of the SAS controller (3).
Ê Route the cables as shown.
RX300 S7
"Installing the front LAN connector" on page 426
Upgrade and Maintenance Manual
Conversion configurations
417.
519