Switching On The Id Indicator - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Ê In the initial Installation Manager startup window, choose either Update
Manager Express or PrimeCollect from the Installation Manager mode section.
Ê Click Continue to proceed.
If Update Manager Express has been selected, insert the ServerView Update
DVD into the DVD drive before proceeding.
Ê Finish the intended maintenance task. For further information, refer to the
following manuals:
– ServerView Update Manager Express:
"Local System Update for PRIMERGY Servers" user guide
– PrimeCollect:
"PrimeCollect" user guide
Ê After the update or diagnostic procedure has been completed, shut down the
server, reconnect all external I/O connections and bring the system back to
normal operation.
Ê If necessary, perform this procedure for all remaining servers within the
Multipath environment.
5.1.6

Switching on the ID indicator

When working in a datacenter environment, switch on the ID indicator on the
front and rear connector panels of the server for easy identification.
I
For further information, refer to section
page 56 or to the "ServerView Suite Local Service Concept (LSC)"
manual.
Using the ID button on the front panel
Ê Press the ID button on the front panel to switch on the system identification
LEDs.
I
For further information, refer to section
indicators" on page
Using the iRMC web frontend
Ê Enter the ServerView iRMC web frontend.
Ê Under System Overview, click Identify LED On to switch on the ID indicators.
RX300 S7
555.
Upgrade and Maintenance Manual
Basic software procedures
"Locating the defective server" on
"Front panel controls and
91