Hard disk drives / solid state drives
7.4.1.5
Concluding steps
Perform the following procedures:
"Installing the fan box" on page 184
Ê
"Installing the air duct" on page 74
Ê
"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reinstall all HDD / SSD modules to their original drive bays as described in
section
"Installing 3.5-inch HDD modules" on page
"Connecting the server to the power source" on page 81
Ê
"Enabling BitLocker functionality" on page 107
Ê
"Closing the rack door" on page 84
Ê
7.4.2
Replacing the 4x 2.5-inch HDD SAS backplane
Field Replaceable Units (FRU)
Average task duration: 10 minutes
7.4.2.1
Required tools
Preliminary and concluding steps:
●
– Phillips PH2 / (+) No. 2 screw driver
Replacing the SAS backplane:
●
– Phillips PH2 / (+) No. 2 screw driver
7.4.2.2
Preliminary steps
Perform the following procedures:
164
Upgrade and Maintenance Manual
77.
140.
RX300 S7