Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual page 195

"Mounting the server cover" on page 76
Ê
"Sliding the server into the rack" on page 80
Ê
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the server to the power source" on page 81
Ê
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section
Ê In order to configure an expansion card that has been installed or replaced,
the card's Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section
page 97.
"Enabling SVOM boot watchdog functionality" on page 101
Ê
"Enabling BitLocker functionality" on page 107
Ê
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page
"Closing the rack door" on page 84
Ê
RX300 S7
"Updating RAID controller firmware" on page
Upgrade and Maintenance Manual
Expansion cards and backup units
77.
"Enabling Option ROM scan" on
112.
96.
195