Assigning The W310 Ip Address - Avaya W310 User Manual

Assigning the W310 IP Address

All W310 switches are shipped with the same default IP address. You must change the
IP address of the W310 switch in order to guarantee that it has its own unique IP address
in the network.
The network management station or a workstation running a Telnet session can establish
communications with the switch once this address had been assigned and the switch has been
inserted into the network. Use the CLI to assign the W310 an IP address and net mask.
To assign the IP address:
1 Establish a serial connection by connecting a terminal to the W310 switch.
2 When prompted for a Login Name, enter the default name root
3 When you are prompted for a password, enter the password root.
4 At the prompt, type:
set interface inband <vlan> <ip_address> <netmask>
Replace <vlan>, <ip_address> and <netmask> with the VLAN,
IP address and net mask of the switch.
5 Press Enter to save the IP address and net mask.
6 At the prompt, type reset and press Enter to reset the switch. After the Reset, log in
again as described above.
7 At the prompt, type set ip route <dest> <gateway> and replace <dest> and
<gateway> with the destination and gateway IP addresses.
8 Press Enter to save the destination and gateway IP addresses.
Avaya W310 User's Guide
You are now in Supervisor Level.
Chapter 7 Establishing Switch Access
37