Establishing A Telnet Connection - Avaya W310 User Manual

Establishing a Telnet Connection

Perform the following steps to establish a Telnet connection to the W310 for configuration:
1 Connect your station to the network.
2 Verify that you can communicate with the W310 using Ping to the IP of the W310. If
there is no response using Ping, check the IP address and default gateway of both the
W310 and the station.
3 From the Microsoft Windows taskbar of your PC click Start and then Run (or from the
DOS prompt of your PC), then start the Telnet session by typing: telnet
<W310_IP_address>
— For example: telnet 149.49.32.134
4 If the IP Address in the Telnet command is the IP address of the switch, then the
connection is established with the Switch CLI entity.
5 When you see the "Welcome to W310" menu and are prompted for a Login Name, enter
the default name root
6 When you are prompted for a password, enter the Supervisor Level password root in
lower case letters (do not use uppercase letters).
7 Go to
Avaya W310 User's Guide
The W310 default IP address is 149.49.32.134 and the default subnet mask is
255.255.255.0.
The User level prompt will appear when you have established communications
with the W310.
You can now configure the W310
Assigning the W310 IP
Chapter 7
Address.
Establishing Switch Access
35