Allowed Managers; Allowed Manager Cli Commands - Avaya W310 User Manual

Allowed Managers

With the Allowed Managers feature, the network manager can determine who may or may
not gain management access to the switch. The feature can be enabled or disabled (default is
disabled). When enabled, only those users that are configured in the Allowed Managers table
are able to gain Telnet, HTTP, and SNMP management access to the switch.
You can configure up to 20 Allowed Mangers by adding or removing their IP address from
the Allowed Managers List.
Note: The identification of an "Allowed Manager" is done by checking the Source IP
address of the packets, thus if the Source IP address is modified on the way (Network
Address Translation (NAT), Proxy, etc.), even an "Allowed Manager" will not be able to
access the W310.

Allowed Manager CLI Commands

In order to...
When set to enabled - only managers
with ip address specified in the allowed
table will be able to access the device
Add/delete ip address of manager to/
from the allowed table
Show the IP addresses of the managers
that are allowed to access the device
Show whether the status of allowed
managers is enabled or disabled
Show the IP addresses of the managers
that are currently connected
Avaya W310 User's Guide
Chapter 8
Use the following command...
set allowed managers
set allowed managers ip
show allowed managers table
show allowed managers status
show secure current
User Authentication
49