Specifications; Lx Transceiver; Sx Transceiver; Elx Transceiver - Avaya W310 User Manual

Specifications

LX Transceiver

• To connect to a 1000Base-LX SFF/SFP GBIC port, use one of the following:
— A 9 µm or 10 µm single-mode fiber (SMF) cable. The maximum length is 10 km
(32,808 ft).
— A 50 µm or 62.5 µm multimode (MMF) fiber cable. The maximum length is 550 m
(1,804 ft.).
• The LX transceiver has a Wavelength of 1300 nm, Transmission Rate of 1.25 Gbps,
Input Voltage of 3.3V, and Maximum Output Wattage of -3 dBm.

SX Transceiver

To connect to a 1000Base-SX SFF/SFP GBIC port, use a 50 µm or 62.5 µm multimode
•
(MMF) fiber cable. The maximum length is 500 m (1,640 ft.).
• The SX transceiver has a Wavelength of 850 nm, Transmission Rate of 1.25 Gbps,
Input Voltage of 3.3V, and Maximum Output Wattage of -4 dBm.

ELX Transceiver

To connect to a 1000Base-ELX SFP GBIC port, use a 9 µm or 10 µm single-mode fiber
•
(SMF) cable. Ensure that the fiber length is between a minimum length of 10 km
(32,808) and a maximum length of 70 km (229,656 ft.). The fiber attenuation must be
less than 0.3 dB/km for 70 km of fiber length.
• The ELX transceiver has a Wavelength of 1550 nm, Transmission Rate of 1.25 Gbps,
Input Power of 3.3V, and Maximum Output Optical Power of +5 dBm.

Copper GBIC Transceiver Installation Notes

Before installing a copper SFP transceiver, ensure that auto-negotiation is enabled for the
transceiver ports. You should also ensure that the auto-negotiation is enabled for the port at
the other end of the link:
1 Use the
ports.
2 Use the
autonegotiation if necessary.
Avaya W310 User's Guide
command to check the auto-negotiation status of the transceiver
show port
set port negotiation <module>/<port> enable
Chapter 3 Specifications
command to enable
11