Avaya W310 User Manual page 123

The following table provides a list of the fields in the IP Multicast Filtering dialog box and
their descriptions:
Table 11.13 IP Multicast Filtering Parameters
In order to . . .
Enable or disable IP
multicast filtering
Set the host aging time
Set the router aging time
Set the delay time
between receiving an IP
multicast session request
and the time IP multicast
filtering begins
To change the IP Multicast filtering configuration for the Avaya W310 Device, change the
IP Multicast filtering parameters described above.
• To apply the changes, click Apply.
• To refresh the information in the IP Multicast Filtering dialog box, click Refresh.
Avaya W310 User's Guide
Chapter 11 W310 WLAN Gateway Layer 2 Features
Do the following . . .
In the Filtering Mode field, from the drop-down menu,
select the mode of operation of the IP Multicast Filtering
on the device. Modes include:
• Enable - IP Multicast Filtering is enabled on the
device.
• Disable - IP Multicast Filtering in not enabled on the
device.
In the Host Aging Time field, enter the amount of time (in
seconds) allowed to pass from a router's last IP Multicast
request before the W310 stops forwarding all multicast
sessions to a router. The valid range for this parameter is
30 - 7200 seconds.
In the Router Aging Time field, enter the amount of time
(in seconds) allowed to pass from a router's last IP
Multicast request before the router is released from the
device's IP Multicast routing table. The valid range for
this parameter is 30 - 7200 seconds.
In the Delay Time field, enter the amount of time (in
seconds) the device waits from receiving a request for a
new IP Multicast session until IP Multicast filtering
begins. This time allows other hosts to report to the device.
The valid range for this parameter is 1 - 300 seconds.
97