Setting Up Timers For Ip Multicast Filtering; Ip Multicast Cli Commands - Avaya W310 User Manual

Setting Up Timers for IP Multicast Filtering

IP Multicast Filtering configuration is associated with the setting up of three timers:
• The Router Port Pruning timer ages out Router port information if IGMP queries are
not received within the configured time.
• The Client Port Pruning timer ages out client port information if IGMP reports are not
received within the configured time.
• The Group Filtering Delay time is the time that the switch waits between becoming
aware of a Multicast group on a certain VLAN and starting to filter traffic for this group.

IP Multicast CLI Commands

The following table contains a list of the CLI commands for the IP Multicast feature. The
rules of syntax and output examples are all set out in detail in the W310 CLI Reference
Guide.
Table 11.12 IP Multicast CLI Commands
In order to...
Enable or disable the IP multicast
filtering application
Define aging time for client ports
Define aging time for router ports
Define group filtering time delays
Display the status IP multicast filtering
application
Shows whether the connected unit's
hardware supports IP multicast filtering
Avaya W310 User's Guide
Chapter 11 W310 WLAN Gateway Layer 2 Features
Use the following command...
set intelligent-multicast
set intelligent-multicast client port
pruning time
set intelligent-multicast router port
pruning time
set intelligent-multicast group-filtering
delay time
show intelligent-multicast
show intelligent-multicast hardware-
support
95