Tcp Establish Bit (Access Control Lists Only); Operation - Avaya W310 User Manual

Configuring Policy
The following command specifies an ICMP echo reply packet for rule 1 in QoS list 401:
W310-1(QoS 401/rule 1)# icmp Echo-Reply
The following command specifies any ICMP packet except type 1 code 2 for rule 5 in access
control list 321:
W310-1(ACL 321/ip rule 5)# not icmp 1 2

TCP Establish Bit (Access Control Lists only)

Use the
tcp established
of an established TCP session. Use the
applies to all TCP packets. In either case, the command also sets the IP protocol parameter to
TCP.
The following command specifies that rule 6 in access control list 301 only matches packets
that are part of an established TCP session:
W310-1(ACL 301/ip rule 6)# tcp established

Operation

Use the
operation
operation for the W310 to perform on a packet when the packet matches the rule. For an
explanation of composite operations, see
The operation field for access control lists has a default value of Permit. See
Composite Operations for Access Control
The operation field for QoS lists has a default value of Trust-DSCP-CoS. See
Composite Operations for QoS
The following command specifies that rule 4 in access control list 302 drops packets that
match the rule, and causes the W310 to send a trap and reset the connection when the packet
is dropped:
W310-1(ACL 304/ip rule 4)# operation Deny-Notify-Rst
Note: Composite operation names are case-sensitive.
254
command to specify that the rule only applies to packets that are part
form of this command to specify that the rule
no
command, followed by the name of a composite operation, to specify an
Composite
Lists.
Operations.
Lists.
Pre-configured
Pre-configured
Avaya W310 User's Guide