Before You Install The W310 In A Rack; Placing The W310 In The Rack - Avaya W310 User Manual

Before You Install the W310 In a Rack

1 When installing a W310 in a rack, ensure that equipment is positioned such that it will
not cause the rack to become unstable or tip over.
2 Ensure that the combination of equipment in the rack will not cause an overload or
overcurrent condition on the power strip being used and/or the customer's branch circuit.
3 The W310 units weigh a maximum of 12 pounds (5.5 kg). Be careful when installing or
removing the W310 product from the rack.
4 If a power strip is being used in the rack, ensure that it has a reliable earth connection. If
the W310 equipment will be plugged directly into a wall outlet, ensure that there is a
reliable ground connection at the outlet.
5 Ensure that the internal rack ambient temperature is within the operating specification
limits of the W310.
6 Ventilation for the W310 is from side to side. Ensure that there is adequate space on
each side of the W310 equipment when installed in the rack to allow sufficient airflow.

Placing the W310 in the Rack

Place the W310 in the rack as follows:
1 Using four screws, attach one rack bracket to each side of the unit. Ensure that the "ear"
of the bracket is positioned as required (see Figure 4.1)
2 Position the unit in the rack.
3 Secure the unit to the rack by using a screwdriver inserted through the screw holes on
the front panel, tighten the two floating screws on each of the new rack brackets.
Be careful not to overtighten the screws.
4 Insert the unit into the rack. Ensure that the four W310 screw holes are aligned with the
rack hole positions as shown in Figure 4.1 and Figure 4.3.
Avaya W310 User's Guide
Chapter 4 Installation
17