Pbnac Cli Commands - Avaya W310 User Manual

Chapter 11 W310 WLAN Gateway Layer 2 Features
5 Set the dot1x system-auth-config to enable; the authentication process starts:
— The supplicant is asked to supply a user name and password.
— If authentication is enabled on the port, the Authenticator initiates authentication
when the link is up.

PBNAC CLI Commands

The following table contains a list of the CLI commands for the PBNAC feature. The rules
of syntax and output examples are all set out in detail in the Reference Guide.
Table 11.5 PBNAC CLI Commands
In order to...
Configure dot1x on a system
Disable dot1x on all ports and return to
default values
Display the system dot1x capabilities,
protocol version, and timer values
Display all the configurable values
associated with the authenticator port
access entity (PAE) and backend
authenticator
Display all the port dot1x statistics
Set the minimal idle time between
authentication attempts
Set the time interval between attempts
to access the Authenticated Station
Set the server retransmission timeout
period for all ports
76
• Authentication Succeeds: after the authentication process completes, the
supplicant will receive a Permit/Deny notification.
• Authentication Fails: authentication will fail when the Supplicant fails to
respond to requests from the Authenticator, when management controls
prevent the port from being authorized, when the link is down, or when the
user supplied incorrect logon information.
Use the following command...
set dot1x
clear dot1x config
show dot1x
show port dot1x
show port dot1x statistics
set dot1x quiet-period
set dot1x tx-period
set dot1x server-timeout
Avaya W310 User's Guide
Continued