Network Time Acquiring Protocols Parameter Configuration - Avaya W310 User Manual

Chapter 10 Basic Switch Configuration
Table 10.1
In order to . . .
View the device's system
description
View the number of
modules installed on the
device
Set the management
VLAN
View the device's
operational status

Network Time Acquiring Protocols Parameter Configuration

The W310 can acquire the time from a Network Time Server. W310 supports the
• Simple Network Time Protocol (SNTP) Protocol (RFC 958) over User Datagram
Protocol (UDP) port 123 or
• TIME protocol over UDP port 37.
Use the CLI commands briefly described below for configuring and display time
information and acquiring parameters.
In order to...
Restore the time zone to its default,
UTC.
Configure the time zone for the system
Configure the time protocol for use in
the system
56
Device Information Fields - General Tab (Continued)
Do the following . . .
See the System Description field for a description of
the device and its current software version.
See the Number of Modules field. This is 1 by default.
Use the Management VLAN field to enter the VLAN
of which this device is a member. If you change the
management VLAN, you must reset all W310s in your
domain so that the change takes effect.
See the Operational Status field to view the operational
status of the device. Possible values are:
• OK - Device is functioning normally.
• Down - Device is reporting errors that make it
unable to function.
• Fatal - Device is reporting errors that are not
recoverable.
Use the following command...
clear timezone
set timezone
set time protocol
Avaya W310 User's Guide
Continued