Configuring An Access Point Group Interface; Ap Group Cli Commands - Avaya W310 User Manual

Chapter 12 W310 WLAN Gateway Wireless Features

Configuring an Access Point Group Interface

To create an Access Point Group interface, use the following procedure. A default AP Group
exists named "default" which allows all traffic.
1. Assign a name to the Access Point Group Interface.
W310-1(super)#interface AP-Group engineering
W310-1(super/AP-Group engineering)
2. Add the W310 ports that are connected to the Access Points you want in the AP Group.
W310-1(super/AP-Group engineering)#add-ports 8-12
W310-1(super/AP-Group engineering)
3. Check your entries by using the show command.
W310-1(super/AP-Group engineering)#show AP-Group
AP-Group Name
---------------------
floor1
W310-1(super/AP-Group engineering)

AP Group CLI Commands

In order to...
Enter or create an Access Point Group
interface. The default AP Group is
named "Default". The default AP
Group allows all wireless network
traffic.
Add W310 ports to the AP Group
interface
Remove W310 ports from an AP
Group interface
Display the AP Group's interface
parameters and port members
174
AP-Group Id ports
----------- ------
1 8 9 10 11 12
Use the following command...
interface AP-Group
add-ports
delete-ports
show ap group
Avaya W310 User's Guide