Avaya W310 User Manual page 244

Chapter 12 W310 WLAN Gateway Wireless Features
Table 12.12 LAP Template Configuration Dialog Box - Advanced - 802.11a/802.11g Tab
Field
Set the unicast
transmission rate
Set the beacon
transmission period
Set the DTIM period
Enable or disable
automatic channel
selection
Select the channel
frequency manually
218
Parameters (Continued)
Description
From the Unicast Tx Rate field drop-down menu, select the
rate at which the transceiver transmits unicast traffic.
Possible values: 0 (auto-fallback) - 54Mbps.
In the Beacon Period field, enter the amount of time between
beacon transmissions.
In the DTIM Period field, enter the number of beacon
periods between transmission of DTIM (Delivery Traffic
Indication Map) count frames with a value of zero.
From the Automatic Channel Selection drop-down menu,
select Enable to allow the LAP to select its channel
frequency automatically. Select Disable to select the channel
manually.
Automatic Channel Selection automatically enables when the
Regulatory Domain is ETSI.
From the Channel Frequency drop-down menu, select the
current operating frequency of the LAP. This field is active
only when Automatic Channel Selection is disabled.
If you disable Automatic Channel Selection
through the W310 Device Manager or the CLI
(channel-selection selective),
then you must set the Channel Frequency for
the W110
Avaya W310 User's Guide