Exiting The Supervisor Level; Entering The Cli Or The W310 Device Manager; Entering The Cli; Entering The W310 Manager - Avaya W310 User Manual

Exiting the Supervisor Level

To exit the Supervisor level, type the command exit.

Entering the CLI or the W310 Device Manager

Entering the CLI

To enter the CLI, enter your username and password. Your access level is indicated in the
prompt as follows:
• The User level prompt is shown below:
W310>
• The Privileged level prompt is shown below:
W310#
• The Configure level prompt for Layer 3 configuration is shown below:
W310-N(configure)#
• The Supervisor level prompt is shown below:
W310(super)#

Entering the W310 Manager

If you installed the Avaya W310 Manager as part of Avaya Network Management, the
following table provides instructions for starting Avaya W310 Manager.
If you run the Avaya W310
Manager from:
Avaya Network Management
Console
Avaya W310 User's Guide
Then use this procedure:
From the network management map:
1 Select the Avaya W310 Device you want to
manage.
2 Click .
Or
Double-click on the Avaya W310 Device.
Or
Select Tools > Avaya Device Manager.
Chapter 8 User Authentication
Continued
41