Reconfiguring Existing Dchannels On An Ntbk51Aa/ Ntbk51Aae5/Ntbk51Cae5 (And Later); Changing The Protocol On An Established D-Channel Using Element Manager - Avaya Communication Server 1000 Installation And Commissioning Manual

LD 22, LD 96 and LD 17.
Manager on page 99 describes how to use Element Manager to change the protocol on an
established D-channel.
Reconfiguring existing Dchannels on an NTBK51AA/NTBK51AAE5/
NTBK51CAE5 (and later)
1. Log on to the CS 1000E.
2. Enter the command: LOGI
3. Enter the username.
4. Enter the password.
5. To access LD 22, enter: LD 22
6. Determine the MSDL which hosts the D-Channel to be changed.
7. At the prompt, enter: prt
8. Enter: adan dch x
9. Enter: End
10. Access LD 96 and enter the command: LD 96
11. Enter: dis msdl x y z all
12. Exit LD 96.
13. Make the required changed to the D-Channel in LD 17.
14. Access LD 96 and enter:

Changing the protocol on an established D-channel using Element Manager

1. Log on to Element Manager.
2. In the sidebar, click on the Routes and Trunks » D-Channels link.
3. Click on the EDIT button beside the D-Channel you want to change.
Media Gateway 1000E PRI Gateway Installation and Commissioning
Changing the protocol on an established D-channel using Element
System response: USERID?
System response: PASS?
System response: TYPE
Where x is the D-Channel number
System response: MG_CARD x y z
Where x = loop, y = shelf, z = card
Where x, y, and z are the values returned in LD 22
enl msdl x y z all
Where x, y, and z are the values returned in LD 22
The D-Channel property page appears.
Configure E1/T1 ports on a Call Server
March 2013 99