External Signal Interface (Ext) - SATO CL4NX Operator's Manual

7 Appendix
7.7.6

External Signal Interface (EXT)

This interface complies with the IEEE1284 standard.
Basic Specifications
Connector
Signal Levels
Connector Pin Specifications
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
*
252
CL4NX Operator Manual
Centronics IDC Type 14 pin (female)
High-level : +4.2 to +5.0 V
Low-level : +0.0 to +0.7 V
7
14
I/O
Output Outputs a low signal when the paper end is detected.
- Reference Signal Ground
Output Outputs a low signal when the ribbon end is detected.
Output Outputs a low signal when an error such as the head open error is
detected.
Input Prints one media when a low signal is detected.
Output Outputs a signal when the media print is completed.
Input Prints the same media again when a low signal is detected.
Input External power supply: 5 V
Output Outputs a low signal when the printer changes to offline mode.
Output Outputs a high signal when the ribbon near end is detected.
- -
- +24 V ± 10%
- Vcc +5 V
- -
Output Outputs a low signal when the dispense is completed.
You can set the pin number for output through the Settings > Inter-
face > External I/O > Signals >
1
8
Description
Outputs menu.