Paper Sensor - SATO CL4NX Operator's Manual

4 Operation and Configuration

Paper Sensor

Tools > Test print > Paper Sensor
Print the detection result of the media sensor level.
1. Check and set the items as listed on the Paper Sensor menu.
The setting items are as follows.
2. Press the right soft button to start the test print. Press the right soft but-
ton again to pause the print.
To stop the test print, first pause the print and then press the
1 Label Width
2 Label Length
3 Pitch
4 Offset
5 Darkness Adjust
160
CL4NX Operator Manual
Shows the necessary media width of the test
print.
The necessary media width is 101.6 mm (4")
for Large and 50.8 mm (2") for Small.
Set the length of one piece of the media used
for the test print.
The setting range is 400 to 1600 dots.
Set the print position in the vertical direction.
The setting range is as follows:
The setting range varies depending on the print
resolution of the printer.
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi:-45 to 0 to 45 dots
• 609 dpi:-90 to 0 to 90 dots
When you decrease the setting value, the print
position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the print
position moves opposite the feed direction
(toward the end part of the media).
Set the stop position of the media.
The setting range is as follows:
The setting range varies depending on the print
resolution of the printer.
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi:-45 to 0 to 45 dots
• 609 dpi:-90 to 0 to 90 dots
When you decrease the setting value, the stop
position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the stop
position moves opposite the feed direction
(toward the end part of the media).
Fine tune the print darkness of the test print.
0 is the lightest and 99 is the darkest.
button.
Note:
The value of Label Length,
Pitch, Offset and Darkness
Adjust set in the Paper Sen-
sor menu will reflect to the
same item settings in the
Factory menu, Configure
List menu and Configure
QR menu.