Print Mode - SATO CL4NX Operator's Manual

4 Operation and Configuration

Print Mode

Printing > Print Mode
Set the print mode.
The options are as follows:
• Continuous: Print the specified number of media. The media remains
in position for printing at all times.
• Tear-Off: After printing the specified number of media, the printer feeds
the last media so that it is fully extended out of the printer's front for
removal. After printing, tear off the media manually.
• Cutter: Cut each media while printing the specified number of media.
You can specify this option only when you have installed the cutter unit.
• Linerless: Cut each label while printing the specified number of labels.
You can specify this option only when you have installed the linerless
cutter unit.
• Cut & Print: Cut the media after printing the specified number of
media. You can specify this option only when you have installed the cut-
ter unit.
• Dispenser: Peel the liner from the printed label as it is advanced to the
printer's front. Once the printed label has been removed from the
printer for application, the next label will retract and position itself for
printing. You can specify this option only when you have installed the
dispenser unit.
Note:
You cannot set the Print Mode if Auto-mode is Enabled.
Backfeed
Printing > Backfeed
Backfeed is applicable only when the print mode is set to cutter mode, dis-
penser mode or linerless mode.
The options are as follows:
• None: Do not backfeed.
• After: After cut, backfeed the front part of the next media to the print
head position. For dispenser mode, backfeed the front part of the next
label after dispensing the label.
• Before: Before printing, backfeed the front part of the media to the print
head position.
72
CL4NX Operator Manual