SATO CL4NX Operator's Manual page 129

EXT I/O Re-print
Interface > External I/O > EXT I/O Re-print
Set the reprint function for use with the external terminal.
The options are as follows:
• Enabled: Enable the reprint function.
• Disabled: Disable the reprint function.
RFID
Interface > RFID
Perform the RFID settings.
*Shows only for the RFID model.
The setting items are as follows:
1 Antenna Pitch
2 Write Power
3 Read Power
4 Tag Offset
5 Reader Model
6 Reader Version
7 View
8 Retry Mode
9 Retries
10 Mark bad tags
11 MCS
12 Log RFID Data
13 Data To Record
14 Output Error
Mode
15 Pulse Length
16 Counters
Set the antenna pitch.
Set the antenna power for writing data to the
RFID tag.
Set the antenna power for reading data from
the RFID tag.
Set the tag offset.
Shows the RFID module model.
Shows the RFID module firmware version.
Shows the RFID tag data.
Set the mode for the RFID error.
Set the number of reprints for the RFID error.
Set the error print for the RFID tag error.
Set the Multi vendor Chip-based Serialization.
Set the log function to record the RFID data.
Set the data to be recorded.
Set the output signal for the RFID error.
Set the pulse length of the output signal for the
RFID error.
Set the RFID counter.
4 Operation and Configuration
CL4NX Operator Manual
127