SATO CL4NX Operator's Manual page 198

6 Troubleshooting
Error
No.
RFID tag error
1018
RFID system error
1019
Calendar error
1020
BCC check error
1021
Overheat error
1022
196
CL4NX Operator Manual
Message
Could not read/write to the
RFID inlay.
To clear the error:
Press the Cancel
button.
RFID module is not operating
correctly
To clear the error:
Power off the
printer.
The date and time of the cal-
endar IC are incorrect.
To clear the error:
Change the cal-
endar setting,
press the Offline
or button, or
power off the
printer.
The BCC code of the data to
be sent (one item) is incorrect.
To clear the error:
Press the but-
ton or cancel the
print job.
The temperature of the printer
has exceeded its tolerance
value.
To clear the error:
Stop the opera-
tion of the printer
and wait until the
temperature
decreases.
Cause
Discard this tag.
Contact the technical support
center for repair of the RFID
module.
Check if you have installed the
calendar IC or replace the cal-
endar PCB.
Check the data to be sent and
the communication settings.
button: Continue printing
from the print data where the
BCC error occurred.
Send the SUB command:
Clear the BCC error and con-
tinue printing from where it
stopped.
Stop the operation of the
printer to let the temperature
decrease.
Countermeasure