SATO CL4NX Operator's Manual page 128

4 Operation and Configuration
Outputs
Interface > External I/O > Signals > Outputs
Set the output pin No. of the signal.
/
Press the
change, then press the
Press the button to save the settings and return to the Signals menu.
The setting items are as follows:
1 Paper End/
Paper/Ribbon End
(If RFID Mode is
enabled)
2 Ribbon End/
RFID Tag Error (If
RFID Mode is
enabled)
3 Machine Error/
Machine/RFID
Error (If RFID
Mode is enabled)
4 Print Done
5 Qty/Offline
6 Ribbon Near End
7 Dispenser
The options for each signal outputs are as follows:
• PIN1: Set the selected signal to 1PIN.
• PIN3: Set the selected signal to 3PIN.
• PIN4: Set the selected signal to 4PIN.
• PIN6: Set the selected signal to 6PIN.
• PIN9: Set the selected signal to 9PIN.
• PIN10: Set the selected signal to 10PIN.
• OFF: Set the selected signal to off mode.
Note:
You cannot set any outputs using the same pin number. If you attempt to
set the same number, the settings will show in red and you cannot save
the settings.
126
CL4NX Operator Manual
arrow buttons to highlight the item that you want to
/
arrow buttons to change the pin No.
Set the output pin No. of the Signal Paper End.
Set the output pin No. of the Signal Paper/Rib-
bon End if you have installed the RFID.
Set the output pin No. of the Signal Ribbon
End.
Set the output pin No. of the Signal RFID Tag
Error if you have installed the RFID.
Set the output pin No. of the Signal Machine
Error.
Set the output pin No. of the Signal Machine/
RFID Error if you have installed the RFID.
Set the output pin No. of the Signal Print Done.
Shows Qty if you have selected MODE1 in the
EXT 9PIN menu.
Shows Offline if you have selected MODE2 in
the EXT 9PIN menu.
Set the output pin No. of the Signal Qty/Offline.
Set the output pin No. of the Signal Ribbon
Near End.
Set the output pin No. of the Signal Dispenser.
*To use this signal, connect the Dispenser unit
or Linerless cutter unit.
(If RFID Mode is enabled)