SATO CL4NX Operator's Manual page 77

Horizontal
Printing > Imaging > Horizontal
Set the print position in the horizontal direction.
Set the offset value from the print reference position using '+' to move to
the left side and '-' to move to the right side of the printer (when facing the
front of the printer).
The setting range is -792 to +792 dots.
Advanced
Printing > Advanced
Set detailed sensor operation and print motion.
The setting items are as follows:
1 Calibrate
2 Head Check
3
Head Check Mode
4
Every Page
5 Check Media Size
6 Adjustments
7
Start Online
8
Feed After Error
9 Feed At Power On
10 Max Feed
11
Paper End
12 Head Base Position
13 Prioritize
14 Reprint
Adjust the media sensor.
Check if there is a filament disconnection of the
print head.
Set the mode for head check.
*Shows only if you have selected All or Bar-
code in the Head Check menu.
Set the interval for head check.
*Shows only if you have selected Every Page
in the Head Check Mode menu.
Enable or disable media size check.
*Shows only if you have selected Gap or I-
Mark in the Sensor Type menu.
Correct the offset, print position and print dark-
ness.
Start in online mode at power on.
Feeds the media when an error occurs.
Automatically feeds the media at power on.
Set the length to feed after printing.
Select the sensor for sensing the paper end.
Set the edge position for printing.
Select the prioritized setting.
Enable or disable the reprint function.
4 Operation and Configuration
CL4NX Operator Manual
75