Adjusting The Media Stop Position - SATO CL4NX Operator's Manual

5 Cleaning and Performing Printer Adjustments
5.3.3

Adjusting the Media Stop Position

Set the Offset in the Printing > Advanced > Adjustments menu to adjust the media stop position.
Media feed direction
Adjustment for
"+" value
adjustment
Adjustment for
"-" value
Notes
• The above cut reference position for printing indicates the label stop position when the media sensor is set
to Gap sensor.
• You can also adjust when the operation mode is specified to Tear-off or Dispenser.
Adjust the stop position using the procedures as follows:
1
When the printer is in online mode, press
the button on the operator panel to
change to offline mode
2
Press the
menu.
184
CL4NX Operator Manual
Cut position
No
button to show the Settings
Print position
(Print head)
-3.75 mm (-0.15") ~ +3.75 mm (+0.15")
Setting range:
203 dpi: -30 to +30 dot
305 dpi: -45 to +45 dot
609 dpi: -90 to +90 dot