Loading Media With The Optional Cutter; Loading Media With An Optional Dispenser And Liner Discharge Outlet - SATO CL4NX Operator's Manual

3 Loading the Ribbon and Media
3.5.3

Loading Media with the Optional Cutter

Refer to the procedures in
load the media.
For models with a cutter installed, pull the tab
the cutter unit in the direction shown, then open up
the cutter before passing the media through it.
CAUTION
Be careful not to touch the cutter blade.
3.5.4 Loading Media with an Optional Dispenser and Liner Discharge
Outlet
This section describes the procedures to dispense the
label and eject the liner out of the printer.
1
Refer to steps 1 through 6 of
3.5.1 Loading Media Roll
media.
2
Press the tab  at the front of the printer to
open the dispenser unit .
40
CL4NX Operator Manual
Section 3.5.1 Loading Media Roll
of

Section
to load the
or
Section 3.5.2 Loading Fan-fold Media
2
2
1
to
1
1