Loading Fan-Fold Media - SATO CL4NX Operator's Manual

7
Press down on the print head until the
head lock lever is locked.
8
Press the media guide  lightly against
the end of the media, then turn the knob 
to lock the media guide.
9
Close the top cover.
10
After loading the media and ribbon, perform
a test print to make sure that the media is
loaded correctly.
Refer to the Test Print
Menu for details on how to perform a test print.
CAUTION
• When closing the top cover, be careful not to pinch your fingers.
3.5.2

Loading Fan-fold Media

Place the fan-fold media on a flat location, then load the media from the rear of the printer or from the
media slot on the bottom of the printer.
The routing path of the media is shown in
the right figure.
When loading the media, make sure that
the print side faces up.
After passing the media through the slot,
refer to steps 5 through 10 of
3.5.1 Loading Media Roll
media.
Load the media from the
rear of the printer
Load the media from the
bottom of the printer
Note:
If a media jam frequently occurs with the media being loaded from the bottom of the printer, change the load
location to the rear of the printer.
menu in Section 4.4.5 Tools
Section
to load the
3 Loading the Ribbon and Media
CL4NX Operator Manual
3
2
39